Toymods Car Club
www.toymods.org.au
F.A.Q. F.A.Q.    Register Register    Login Login    Home Home
Members Members    Search Search
Classifieds » Miscellaneous » 7M GE - For Sale Soon...Interest?

Show: Today's Posts  :: Show Polls 
Email to friend 
Switch to threaded view of this topic Create a new topic Submit Reply
AuthorTopic
frebbles
Regular


Location:
Canberra
Registered:
May 2002
 
icon5.gif  7M GE - For Sale Soon...Interest? Wed, 22 January 2003 02:11 Go to next message
Just wondering if anyone wants a 7M-GE from a Cressida...

340,000 Km on it (It has been a country car, long trips at a time)
at 290,000 it had a head recondition and head gasket replacement, I was surprised at how little oil this burns. They have a damn strong bottom end.

Currently, it has a leaking cam seal, only minor, not much oil gets out, and the water pump needs a recondition i think...Small amounts of coolant drying up under the water pump...

It still runs very well, looked after and I've replaced the o2 sensor 5,000km ago, it gets around 12-13km/L of fuel around town, a bit less on the highway. Still has fresh filters(Oil and air).

7M-GE was taken out cos I wanted to put the 1J in, no other reason, I gotta get back to uni in a few weeks so it had to be done, I just dont want this engine to go to waste.

I'm not looking for much for it, but i'm not giving it away.
Any interest pm me or post.
Thanks guys.
  Send a private message to this user    
clubagreenie
Forums Junkie


Location:
1st street on the right
Registered:
November 2002
 
Re: 7M GE - For Sale Soon...Interest? Thu, 23 January 2003 22:46 Go to previous messageGo to next message
Does it come with all the trimmings (harness etc?)
  Send a private message to this user    
frebbles
Regular


Location:
Canberra
Registered:
May 2002
 
Re: 7M GE - For Sale Soon...Interest? Fri, 24 January 2003 05:08 Go to previous message
I might need the two plugs that plug into the cressida fuse/controls...They are grey and vehicle specific, but the whole loom (Eng-ECU) and (Eng-Dash) etc will all be intact, IE I'm not cutting any cables. I dont even need the ecu so that comes with it too...
I have to add, being honest and all, it is starting to do the big end syndrome ...A bit noisy

[Updated on: Fri, 24 January 2003 05:09]

  Send a private message to this user    
  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic:Must Go TODAY.. Bits & Wheels.
Next Topic:TRD Parts Clearance
Goto Forum:
-=] Back to Top [=-

Current Time: Fri May 3 01:20:38 UTC 2024

Total time taken to generate the page: 0.0051078796386719 seconds

Bandwidth utilization bar

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.