| Author | Topic |
|---|
Location:
Brisbane
Registered:
October 2002
|
|
wjich way does clutch go in
|
Sat, 06 August 2005 02:57
|
 |
which way faces the flywheel
cant do anything else till i know this
|
|
|
Location:
Melbourne
Registered:
May 2004
|
|
Re: wjich way does clutch go in
|
Sat, 06 August 2005 03:20
|
|
First picture side faces the flywheel.
Do it,
Jeremy
|
|
|
Location:
Brisbane
Registered:
February 2003
|
|
Re: wjich way does clutch go in
|
Sat, 06 August 2005 04:25
|
|
|
what he said
|
|
|
Registered:
May 2005
|
|
Re: wjich way does clutch go in
|
Sat, 06 August 2005 04:41
|
|
should be marked, FLYWHEEL THIS SIDE.
otherwise the big chucky part inside the pressure plate
|
|
|
Location:
Brisbane
Registered:
October 2002
|
|
Re: wjich way does clutch go in
|
Sat, 06 August 2005 05:18
|
|
| ra40coupe wrote on Sat, 06 August 2005 14:41 |
should be marked, FLYWHEEL THIS SIDE.
otherwise the big chucky part inside the pressure plate
|
nay
thanx everyone
|
|
|
Location:
Brisbane
Registered:
May 2002
|
|
Re: wjich way does clutch go in
|
Sat, 06 August 2005 14:05
|
|
I got it backwards when I first put my 2JZ together. The results weren't pretty. 
|
|
|
Location:
Brisbane
Registered:
October 2002
|
|
Re: wjich way does clutch go in
|
Sat, 06 August 2005 23:02
|
|
|
i remember that, what happened again
|
|
|
Location:
Brisbane
Registered:
May 2002
|
|
Re: wjich way does clutch go in
|
Mon, 08 August 2005 00:25
|
|
Let's just say the flywheel bolts got "lightened". 
|
|
|
Location:
Perth
Registered:
October 2003
|
|
Re: wjich way does clutch go in
|
Mon, 08 August 2005 00:27
|
|
I also got my 1JZ one backwards.
The results were devistating to my engine.
|
|
|
Location:
Central Coast, NSW
Registered:
February 2005
|
|
Re: wjich way does clutch go in
|
Mon, 08 August 2005 00:37
|
|
what did it do to the engine?
|
|
|
Location:
Brisbane
Registered:
May 2002
|
|
Re: wjich way does clutch go in
|
Mon, 08 August 2005 00:56
|
|
| Merudo wrote on Mon, 08 August 2005 10:37 |
what did it do to the engine?
|
Screwed the crank thrust washers if I recall...
Cheers
Wilbo
|
|
|
Location:
Perth
Registered:
October 2003
|
|
Re: wjich way does clutch go in
|
Mon, 08 August 2005 01:41
|
|
Munted front thrust washer, front thrust washer fell out, rear thrust washer fell out, carnk munted foward thrust faces. Cheaper to buy another wrecker engine than repair 
|
|
|
Location:
Central Coast, NSW
Registered:
February 2005
|
|
Re: wjich way does clutch go in
|
Mon, 08 August 2005 01:41
|
|
HOLY CRAP!
Damn, well you certainly want to be 1000 percent sure you got it in the right way then, huh...
|
|
|
Location:
Pine Rivers QLD
Registered:
April 2005
|
|
Re: wjich way does clutch go in
|
Mon, 08 August 2005 23:17
|
|
2 things, if the clutch is in backwards do you know about it straight away? or does it take time to destroy the motor?
Also is that what a clutch should look like? It looks a bit chopped up. when i had mine out it was fairly clean.
|
|
|
Location:
Brisbane
Registered:
May 2002
|
|
Re: wjich way does clutch go in
|
Mon, 08 August 2005 23:42
|
|
In my case it was immediately obvious I had the clutch in backwards because you could hear the clutch plate grinding against the flywheel bolts. Not a nice sound at all.
|
|
|
Location:
Perth
Registered:
October 2003
|
|
Re: wjich way does clutch go in
|
Tue, 09 August 2005 01:52
|
|
In my case I started the car in neutral, after about 1 minute I clutched in to engage reverse and take off, at this point it made a nasty whining noise (crank grinding thrust washer real bad). I clutched out and put it in neutral again after about 30 seconds the engine stalled and would not sturn over again it had bound up. When I undid my bellhousing bolts the pressure was releaved and the motor turned again but it was short of thrust washers which were now lyng in the sump (didnt know this at the time, took another couple hundred km's of driving and an oil change to find out).
But anyway I should have known there was a problem as I had a fair bit of problems getting the engine and bellhousing to mate up properly.
|
|
|
Location:
brisbane
Registered:
October 2004
|
|
Re: wjich way does clutch go in
|
Tue, 09 August 2005 07:15
|
|
now i know why my old corona made a noise
|
|
|
