Author | Topic |
Location: Brisbane
Registered: October 2002
|
2 wrongs DO make a right
|
Sun, 28 August 2005 04:24
|
|
when i bought my first spare head to have ported, i initially pulled it a apart to see the condition of it, then when i put it back together i put the cams in back to front
when the cams got sent off to the cam specialist, they were labeled back to front {intake labeled exh ect ect}
head was shimmed to suit the back to front cams, this was a bit of an issue when i went to put the engine back together, as to adjust the cams it had ot be at TDC on cyl 4, as to be able to gain access to the dowels, and instead of having the cam locating slots verical, they had to be at "10 and 2"
this time, with my new head, i took the cams and the new head to the port shop, i told him the cams had "I" and "E" on them {which, remember, was back to front}, then HE has fucked up and put them in back to front, which incidentally the way they were supposed to be.
now when i have put this motor together, i have tried to set it up at "10 and 2", but couldnt get the bastard to make power, tried all different cam positions, but to no avail, in the end i was getting confused about what timing combo's i had used, so i said fuck it, i went back to the factory settings of vertial for the 2 slots int he cams
spun the engine over by hand, hmmm, no valve/piston clash, {i'm sure i tried that combo when the motor was going together and they clashed }, took it for a drive, fuck me, goes like a shower of shit now
so my inital fuck up and the fuck up of the porters it turned out to work in the end, and now the cams are back intheir correct possitions, and i have decent adjustability too
yay
|
|
|
Location: sunny coast, qld
Registered: October 2002
|
Re: 2 wrongs DO make a right
|
Sun, 28 August 2005 05:24
|
|
Hehe, good stuff Phil!
|
|
|
Location: Melbourne
Registered: June 2002
|
Re: 2 wrongs DO make a right
|
Sun, 28 August 2005 05:31
|
|
Mr DOHC wrote on Sun, 28 August 2005 14:24 | then HE has fucked up and put them in back to front, which incidentally the way they were supposed to be.
|
dunno alitle confusing slightly over my head lol
Maybe he just worked out you had labelled them wrong and corrected it for you?
|
|
|
Location: Brisbane
Registered: October 2002
|
Re: 2 wrongs DO make a right
|
Sun, 28 August 2005 05:48
|
|
doubt it, he doesnt know shit about these engines
i reckon he just fucked up
|
|
|
Location: Melbourne
Registered: June 2002
|
Re: 2 wrongs DO make a right
|
Sun, 28 August 2005 05:59
|
|
funny shit none the less glad it worked out for you anwyays
|
|
|
Location: Brisbane
Registered: October 2002
|
Re: 2 wrongs DO make a right
|
Sun, 28 August 2005 06:50
|
|
now all i have to do is go and pile-drive the asshole of the guy who did my zorst, it sits hard up against my chassis and vibrates like all buggery
|
|
|