Author | Topic |
Location: Melb, Victoria
Registered: September 2002
|
4AGZE 175mm pulley kit
|
Thu, 01 September 2005 22:05
|
|
It uses a factory pulley complete with damper and a CNC machined 175mm outer modified by Performance Engineering.
Comes with 2 drive belts and idler pulley.
Picture of kit
Email
$350.
|
|
|
Location: Sydney
Registered: June 2003
|
Re: 4AGZE 175mm pulley kit
|
Fri, 02 September 2005 12:41
|
|
how much boost does it run?
I have friend who might be interested.
cheer
|
|
|
Location: Bundaberg, Qld.
Registered: May 2002
|
Re: 4AGZE 175mm pulley kit
|
Sun, 04 September 2005 11:40
|
|
the 175mm pulley gives ~14psi.
RSSTi, do you have a timing pointer with the kit?
|
|
|
Location: Melbourne
Registered: October 2004
|
Re: 4AGZE 175mm pulley kit
|
Sun, 04 September 2005 14:30
|
|
YOU GOT PM!!!
|
|
|
Location: Melb, Victoria
Registered: September 2002
|
Re: 4AGZE 175mm pulley kit
|
Sun, 04 September 2005 21:35
|
|
I don't have a timing pointer with it.
|
|
|
Location: Central Coast
Registered: November 2004
|
Re: 4AGZE 175mm pulley kit
|
Sun, 04 September 2005 23:51
|
|
excuse my ignorance but what is a timing pointer and why is it needed for this kit to be put on?
|
|
|
Location: Melb, Victoria
Registered: September 2002
|
Re: 4AGZE 175mm pulley kit
|
Mon, 05 September 2005 00:02
|
|
It's not required to put the kit on but you must remove the factory pointer to fit the kit and some kits come with a re-located pointer.
|
|
|
Location: Central Coast
Registered: November 2004
|
Re: 4AGZE 175mm pulley kit
|
Mon, 05 September 2005 05:56
|
|
So how did u relocate your pointer when you had this kit on. Is the pointer still required for coil pack gze's?
|
|
|
Location: Melb, Victoria
Registered: September 2002
|
Re: 4AGZE 175mm pulley kit
|
Mon, 05 September 2005 06:58
|
|
Pointer is only there for you to set the ignition timing, it points too top dead center when using a timing light and not required run the engine.
|
|
|
Location: Melb, Victoria
Registered: September 2002
|
Re: 4AGZE 175mm pulley kit
|
Mon, 05 September 2005 21:43
|
|
Pulley sold pending payment.
|
|
|