Toymods Car Club
www.toymods.org.au
F.A.Q. F.A.Q.    Register Register    Login Login    Home Home
Members Members    Search Search
Toymods » Tech & Conversions » question about my compression results

Show: Today's Posts  :: Show Polls 
Email to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
AuthorTopic
jackel
Forums Junkie


Location:
Perth
Registered:
August 2003
 
question about my compression results Thu, 08 September 2005 06:05 Go to next message
just did a compression test and the results are as following



1 181
2 165
3 160
4 172

after putting oil in spark hole about 3 drops

1 189
2 170
3 170
4 180

Tis screwed is it not


Car is a st141 toyota corona

2L 2s-c



  Send a private message to this user    
CrUZsida
Forums Junkie


I supported Toymods

Location:
Australia
Registered:
November 2003
Re: question about my compression results Thu, 08 September 2005 06:09 Go to previous messageGo to next message
To me that means the rings are fine but the valves aren't sealing 100%.


You did do it warm didn't you?


And does it matter?
Isn't the T going in soon?
  Send a private message to this user    
oldcorollas
Forums Junkie


Location:
Kita-Ku, Sapporo, Japan
Registered:
January 2003
 
Re: question about my compression results Thu, 08 September 2005 06:48 Go to previous messageGo to next message
doesn't look that bad at all.. what is spec? 180?
  Send a private message to this user    
FKN16V
Forums Junkie


Location:
NSW, East Coast
Registered:
July 2003
Re: question about my compression results Thu, 08 September 2005 07:00 Go to previous messageGo to next message
I personally dont think the compression results are a problem.

10psi difference might seem like alot, but from wat i see across the many forums i attend, 10psi is acceptable.

Cheers

Steve
  Send a private message to this user    
jackel
Forums Junkie


Location:
Perth
Registered:
August 2003
 
Re: question about my compression results Thu, 08 September 2005 16:39 Go to previous message
i thought my compression would of been all over the chart and not over 100 Razz

just found my engine manual it says

nominal 1178kPa
minimum 880kPa

1 bar = 100kpa


189 = 1300
170 = 1200
170 = 1200
180 = 1250

PSI .. kPa

i think thats calculatored around right?

Very Happy Very Happy

sweet my engine is running above average




with the 3t-gteu i still need a couple of minor things but i need someone to do the wiring i think i'm missing some of it Confused

[Updated on: Thu, 08 September 2005 16:41]

  Send a private message to this user    
  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic:Photos of coilover components/mockup- T3 camberplates/hats, King Springs, Koni sleeve kit
Next Topic:3SGTE TVIS question
Goto Forum:
-=] Back to Top [=-

Current Time: Fri May 3 21:43:52 UTC 2024

Total time taken to generate the page: 0.0058770179748535 seconds

Bandwidth utilization bar

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.