| Author | Topic |
|---|
Location:
Pine Rivers QLD
Registered:
April 2005
|
|
Clutch slipping
|
Sat, 10 September 2005 03:23
|
 |
Hey all,
As most may know i have twin turbo'ed the soarer, but still have the NA clutch and pressure plate, I am working on fixing this asap and i am sure it is slipping and slowly getting worse, as i know have a boost controller and its probably now putting even more power through it.
My question is should i make the boost as low as it goes to prevent extra damage or if it slips it slips and it doesn't matter what my boost is it will still be slipping at the same point?
Thanks
|
|
|
Location:
Pine Rivers QLD
Registered:
April 2005
|
|
Re: Clutch slipping
|
Sat, 10 September 2005 04:04
|
|
|
while we are on the point are all slave cylinders the same? if you upgrade your pressure plate do you have to do anything else?
|
|
|
I supported Toymods
Location:
Perth
Registered:
May 2002
|
|
Re: Clutch slipping
|
Sat, 10 September 2005 05:41
|
|
It depends when it slips, it will always slip under the same load, so if your car can put that load on it on low boost, it aint going to mean squat.
And my slave cylinder is the same as my original one.
|
|
|
Location:
Townsville
Registered:
February 2005
|
|
Re: Clutch slipping
|
Sat, 10 September 2005 05:46
|
|
Its going to depend on flywheel and clutch plate condition if it will continue to slip.
Solution is to drive sensibly for a while until you get it replaced!
|
|
|
Location:
Pine Rivers QLD
Registered:
April 2005
|
|
Re: Clutch slipping
|
Sat, 10 September 2005 07:06
|
|
yeah i will try but there is a skid pan day tomorrow and i am not going to miss it for something like this 
|
|
|
