Yoyo ppl.
Ive recently wound boost on my SC12 to 14psi..BUT..my EA pulley bearing finally seized the other day, and after ripping out my SC i found that half the teflon on one of the rotors was gone... hahaha
How bad is this from :
- engine damage point of view
- SC12 performance point of view
Ive spoken to a few toymods dudes, but i just wanted to make sure its ok to put my SC12 back in like that, because i honestly cant afford a replacement SC12 OR engine....
It wont damage your engine. Losing the teflon coating may mean the SC rotor lobes don't seal as well, so less boost, and may not slide as smoothly over each other, so more SC losses, but nothing catastrophic.
A "new" SC could well be a good investment though.
SC12 / 14 teflon lifting . . how bad is it?
Mon, 19 September 2005 14:50
