Toymods Car Club Inc: Tech & Conversions => T50 Bell Housing Brace

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » T50 Bell Housing Brace - Pics Inside Show: Today's Posts :: Show Polls Email to friend

Author

Topic

agp2002
Regular

Location:
Hobart
Registered:
May 2005

T50 Bell Housing Brace - Pics Inside	Tue, 22 November 2005 22:41

Bolt to the RWD 4A* series block and attach to the T50 Bell Housing. Where do i source some of these from?? Whats the real name for them?? Iain [Report message to a moderator]

Henn
Forums Junkie

Location:
Rosanna, Melb
Registered:
June 2002

Re: T50 Bell Housing Brace - Pics Inside	Tue, 22 November 2005 23:35

I think they are called engine gearbox stays. Source them from any RWD 4A car. Or weld up a pair yourself. I have heard it claimed that leaving them off causes problems very soon, but have no evidence to back that up. Hen [Report message to a moderator]

agp2002
Regular

Location:
Hobart
Registered:
May 2005

Re: T50 Bell Housing Brace - Pics Inside	Tue, 22 November 2005 23:56

Thanks heaps Hen, ill go and source some if i can, just its bit scarce part wise down here in tassie. Iain [Report message to a moderator]

shinybluesteel
Forums Junkie

I supported Toymods

Location:
melbourne
Registered:
June 2002

Re: T50 Bell Housing Brace - Pics Inside	Wed, 23 November 2005 01:38

just to state the obvious here, stays off a 4AC will work fine. [Report message to a moderator]

Previous Topic:	Standard AE86 spring rates (not a question)
Next Topic:	Air-Con on/ overheat

Current Time: Fri Apr 26 17:53:39 UTC 2024

Total time taken to generate the page: 0.0048069953918457 seconds

.:: Contact :: Home ::.