| Author | Topic |
|---|
Location:
Hunter Valley
Registered:
February 2003
|
|
ECU programming/mapping
|
Wed, 01 October 2003 04:41
|
 |
Hye about ECU programming and mapping, right now know nothing about it. DO deal with computers though, Is it hard. Any links that can be suggested to read to educate ones self.
Not like they have tertiary courses on it haha, so besides just saying "experience" how do you learn to do it.....
|
|
|
Location:
sydney
Registered:
March 2003
|
|
Re: ECU programming/mapping
|
Wed, 01 October 2003 04:56
|
|
best way to learn is to blow up the engine
so u dont do it next time
u need a dyno and air fuel ratio meter ( a good one)
there are some guys that can do it on the road by driving and feeling the car but for a begginer dont do it unless u know what lean and rich feels like especially on a forced induction car
|
|
|
Location:
ballarat
Registered:
April 2003
|
|
Re: ECU programming/mapping
|
Wed, 01 October 2003 05:01
|
|
|
i wouldn't fuck with your ecu map setting unless you really knew what you were doing, as sideshow says, very easy to blow an engine up
|
|
|
Registered:
June 2002
|
|
Re: ECU programming/mapping
|
Wed, 01 October 2003 05:14
|
|
|
I say fuck with it. Fuck with it little amounts at a time and make sure you have the right diagnostic gear. Check out diy efi for some timps www.diy-efi.org
|
|
|
I supported Toymods
Location:
Epping, Sydney
Registered:
May 2002
|
|
Re: ECU programming/mapping
|
Wed, 01 October 2003 05:17
|
|
heh
I plan to learn on mine by mucking around.
but that's only because I know it's running rich across the whole range
|
|
|
Location:
ballarat
Registered:
April 2003
|
|
Re: ECU programming/mapping
|
Wed, 01 October 2003 05:46
|
|
| roger wrote on Wed, 01 October 2003 15:14 |
I say fuck with it. Fuck with it little amounts at a time and make sure you have the right diagnostic gear. Check out diy efi for some timps www.diy-efi.org
|
in little amounts its ok, just make sure you know when its pinging
|
|
|
