Author | Topic |

Registered: June 2002
|
tailshaft for ae86 with the 6.7 diff
|
Tue, 09 December 2003 21:08
|
 |
I have been told the tailshaft out of a T18 is the correct length when installing the 6.7 inch Jap diff in an AE86. Is anyone able to confirm for me?
|
|
|
Location: Melbourne
Registered: September 2002
|
Re: tailshaft for ae86 with the 6.7 diff
|
Tue, 09 December 2003 22:01

|
 |
Yes I can confirm that 
Denis
|
|
|
Location: NSW, East Coast
Registered: July 2003
|
Re: tailshaft for ae86 with the 6.7 diff
|
Tue, 09 December 2003 23:50

|
 |
Isnt there some uni-joint issues with this setup, something about the t18 tailshaft is too long or to short, can someone confirm this.
Are these tail shafts common or hard to come-by
Steve
|
|
|

Club Member
Location: sydney
Registered: May 2002
|
Re: tailshaft for ae86 with the 6.7 diff
|
Wed, 10 December 2003 06:50

|
 |
it fits but youll need the matching gearbox to suit the spline on the shaft
|
|
|

I supported Toymods
Location: Ademelaide, SA
Registered: July 2003
|
Re: tailshaft for ae86 with the 6.7 diff
|
Wed, 10 December 2003 08:52

|
 |
or you can find the right t18 shaft, and just use the rear half of it. it bolts to the rear of the ae86 shaft, and to the diff yoke.
last one cost me $30 from gingernuts, who got it from a U-pull-it wreckers...
|
|
|

Registered: June 2002
|
Re: tailshaft for ae86 with the 6.7 diff
|
Wed, 10 December 2003 20:38

|
 |
Thank you
Front is getting Supra yoke so no probem!
|
|
|
Location: Melbourne
Registered: September 2002
|
Re: tailshaft for ae86 with the 6.7 diff
|
Wed, 10 December 2003 22:02
|
 |
Exactly as Steve-AE86 said it - use the rear section of the T18 tailshaft. Works fine.
Denis
|
|
|