| Author | Topic |
|---|
Location:
Melbourne
Registered:
September 2002
|
|
Bigport head w/ Smallport Intake Manifold. Possible?
|
Thu, 20 May 2004 01:42
|
 |
Hey Ppls,
Im just wondering if a smallport manifold was bolted to a bigport head if it would seal properly? I knows its a pretty ugly was of doing things but would it work?
|
|
|
Location:
Melbourne
Registered:
May 2002
|
|
Re: Bigport head w/ Smallport Intake Manifold. Possible?
|
Fri, 21 May 2004 07:49
|
|
|
You would have to make the runners on the inlet actually taper up to the size of the bigport head if you wanted it to seal properly so you could run the right size gasket and drop turbulance at that point significantly. I use the same principle on my turbo manifold.
|
|
|
Banned by his request
Location:
moved to tamworth
Registered:
July 2002
|
|
Re: Bigport head w/ Smallport Intake Manifold. Possible?
|
Fri, 21 May 2004 10:07
|
|
two words! custom inlet !
mick
|
|
|
Location:
Montrose, VIC
Registered:
May 2002
|
|
Re: Bigport head w/ Smallport Intake Manifold. Possible?
|
Sat, 22 May 2004 14:01
|
|
|
Made this mistake once (wasn't looking at the head, bolted on the wrong manifold!!), and no, it didn't start... Damn, did I just admit to this??
|
|
|
