| Author | Topic |
|---|
Location:
Canberra
Registered:
May 2002
|
|
4AGZE ignition leads (OEM)
|
Mon, 26 July 2004 13:10
|
 |
I'm after a set of 4AGZE factory toyota ignition leads. Actually, if you have an incomplete set, i'm specifically after the one for cylinder # 3.
Must be in good condition. 
Thanks in advance
Phil
|
|
|
I supported Toymods
Location:
Perth, Western Australia
Registered:
December 2002
|
|
Re: 4AGZE ignition leads (OEM)
|
Mon, 26 July 2004 13:19
|
|
|
Pretty sure I have one left, either to suit 2 or 3, post the length you need, and I'll check it tomorrow?!
|
|
|
Location:
Canberra
Registered:
May 2002
|
|
Re: 4AGZE ignition leads (OEM)
|
Tue, 27 July 2004 10:39
|
|
Thanks mate, i'll get the measuring tape out tonight.
|
|
|
Location:
Montrose, VIC
Registered:
May 2002
|
|
Re: 4AGZE ignition leads (OEM)
|
Tue, 27 July 2004 14:52
|
|
|
For the sake of $10, I'd just get a new one made to suit... In fact, get a set made and replace the lot, they're probably getting on by now!
|
|
|
I supported Toymods
Location:
Perth, Western Australia
Registered:
December 2002
|
|
Re: 4AGZE ignition leads (OEM)
|
Wed, 28 July 2004 01:25
|
|
|
Last time I had a set made, it was $120 for a 4AGZE, with me supplying both ends.
|
|
|
Location:
Canberra
Registered:
May 2002
|
|
Re: 4AGZE ignition leads (OEM)
|
Wed, 28 July 2004 08:33
|
|
CLG: Thanks for the offer mate, but I obtained a new set from toyota for a good price
MrShin: Where do you get your leads made for such a cheap price??
|
|
|
Location:
Montrose, VIC
Registered:
May 2002
|
|
Re: 4AGZE ignition leads (OEM)
|
Wed, 28 July 2004 12:34
|
|
|
I get them made at a place in Vic called Performance Ignition, they're always helpful/friendly, last time I wanted a set for a 4AGE, I went in there and asked if I could buy some wire to make them, ended up just getting him to stick on new ends and silicon boots (instead of the bakelite ones) for $10 each. He was pretty busy, so I had to wait about an hour, and for each lead I took the roll of wire out to the carpark, and cut it off at the right length. Easy!
|
|
|
Location:
Canberra
Registered:
May 2002
|
|
Re: 4AGZE ignition leads (OEM)
|
Thu, 29 July 2004 11:36
|
|
I wish we had a place like that here!
|
|
|
