Toymods Car Club
www.toymods.org.au
F.A.Q. F.A.Q.    Register Register    Login Login    Home Home
Members Members    Search Search
Toymods » Tech & Conversions » apexi avcr installation

Show: Today's Posts  :: Show Polls 
Email to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
AuthorTopic
tyottsoarer
Regular


Location:
Gold Coast
Registered:
June 2004
apexi avcr installation Tue, 31 August 2004 12:34 Go to next message

Hey i just got my apexi avcr and I was wondering how involved the installation is (Its going onto a 1jz-gte with the stock turbos) If anyone could give me advice id appreciate it

Thanks
  Send a private message to this user    
Soarer
Forums Junkie


Location:
Wollongong
Registered:
May 2002
Re: apexi avcr installation Wed, 01 September 2004 04:20 Go to previous message
You'll need to bridge both wastegate lines, and also both compressor housing lines, then T piece them and use one pipe from each to the AVC-R.

There is a diagram here:
http://web.ukonline.co.uk/soarertt/images/boostble ed1.gif

Instead of the bleed valve, the AVC-R actuator goes there.
  Send a private message to this user    
  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic:adjusting apexi N-1 coilovers
Next Topic:RA28 Steel case 5 sp 240mm (9 1/5') clutch Qs
Goto Forum:
-=] Back to Top [=-

Current Time: Thu Aug 7 15:05:33 UTC 2025

Total time taken to generate the page: 0.0040619373321533 seconds

Bandwidth utilization bar

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.