| Author | Topic |
|---|
Location:
ipswich queensland
Registered:
April 2004
|
|
2tgeu elec ignition wiring diagram
|
Sun, 28 November 2004 02:45
|
 |
does any one have one they can email to me
ive just hooked up the elec coil/ignitor and i have an extra wire and i dont know where its gotta go
its a brown wire, it goes onto the +ve side of the coil then keeps goin, but to where??
thanx
|
|
|
Location:
deloraine tas
Registered:
September 2004
|
|
Re: 2tgeu elec ignition wiring diagram
|
Sun, 28 November 2004 02:56
|
|
|
the brown on mine goes to + side then it ends there and there is a black one the goes to + side then there in a yellow one the goes to - side that should help you out i hope good luck
|
|
|
Location:
ipswich queensland
Registered:
April 2004
|
|
Re: 2tgeu elec ignition wiring diagram
|
Sun, 28 November 2004 09:02
|
|
ok ive got the following done
yellow - tacho
brown - +ve on coil
black - -ve on coil
and ive got all my ecu stuff hooked up too
should this be working??
on my corona i had a look and the same wire im left with goes to the fuse panel could this be constant power??
|
|
|
Location:
Perth
Registered:
September 2004
|
|
Re: 2tgeu elec ignition wiring diagram
|
Sun, 28 November 2004 11:07
|
|
Hey. I have a 2tg (no efi) with the electronic coil and igniter set up, and the brown wire on my coil is not connected to anything - just hanging. Everything seems to be working fine, except for my tacho, which I haven't managed to figure out yet. So I'm guessing it's either something to do with the ECU, because I don't have one, or the tacho. Also, I have a wiring diagram, not sure how much help it will be, but if you want it, pm your email address.
john
|
|
|
