Toymods Car Club Inc: Tech & Conversions => 1J head studs

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 1J head studs Show: Today's Posts :: Show Polls Email to friend

Author

Topic

sxturbo
Occasional Poster

Location:
Central Coast
Registered:
June 2002

1J head studs	Fri, 10 December 2004 22:40

hi does anyone know if 1J head studs are re usable or do i need new ones?? im thinging i need new ones. if so does anyone make them other than toyota as i havent been able to find any from ARP. Thanks [Report message to a moderator]

Stenno
Regular

Location:
Sydney
Registered:
March 2003

Re: 1J head studs	Sat, 11 December 2004 23:57

JZ motors do not use head studs from the factory, they use a TTY (Torque to yield) bolt. These are single use only bolt and must be replaced. Unsure of the headbolt length of a 1JZ but you may be able to use 2JZ headstuds (ARP). [Report message to a moderator]

sxturbo
Occasional Poster

Location:
Central Coast
Registered:
June 2002

Re: 1J head studs	Tue, 14 December 2004 01:10

any chance i could get your chassis numbers so that i can check with toyota to see if the 1j and 2j studs are the same. THanks [Report message to a moderator]

Stenno
Regular

Location:
Sydney
Registered:
March 2003

Re: 1J head studs	Tue, 14 December 2004 10:54

I just had a look, both the same PN 90910-02101. So you can use ARP headstuds. Err not going to hand out my chassis number but JZA80-0021238/JZA80-ALFQZ is from a front cut I had. [Report message to a moderator]

sxturbo
Occasional Poster

Location:
Central Coast
Registered:
June 2002

Re: 1J head studs	Tue, 14 December 2004 11:14

thanks for the reply, that is very helpful. [Report message to a moderator]

Previous Topic:	ke30 strut conversoin comparison
Next Topic:	Your Opinions Plz - Fusion sub and Fusion amp

Current Time: Sun Jul 27 23:01:53 UTC 2025

Total time taken to generate the page: 0.0046579837799072 seconds

.:: Contact :: Home ::.