| Author | Topic |
|---|
Location:
Adelaide
Registered:
September 2003
|
|
FS : Full Floater diff/hubs Going Cheap ;-)
|
Thu, 06 January 2005 22:28
|
 |
Hiya all,
Having a major shed cleanout and stumbled across this hidden away.
Basically it is a Full Floater diff setup from an RX7 Improved Production race car. It does not have a centre, but comes with 3 axles (one has a bit of twist in the splines - maybe 5 degrees), has small solid discs fitted (about 230mm maybe ?) and has about a degree of neg camber in the housing.
I bought it with the option of trying to fit it into my RX2 that I had at the time, but that never eventuated.
Considered a MUST HAVE for any real high performance beam axle car.
It came from SelectMaz, and at the time was surplus to their requirements.
It is now surplus to mine (MA61's are IRS, so hence are already full floaters..), and whilst the housing is not Toyota, the end hubs can be adapted, and new axles made if required.
Anyone interested ?
I can diasassemble the housing and supply only the hubs if anyone is interested
Other than that it is going to the dump
I will accept any reasonable offer (meaning bugger all compared to what it is worth)
Cheers
Michael Bachmann
042 111 9249
[Updated on: Fri, 07 January 2005 02:20]
|
|
|
Location:
Adelaide
Registered:
September 2003
|
|
Re: FS : Full Floater diff/hubs Going Cheap ;-)
|
Sat, 08 January 2005 03:33
|
|
Ok, here are some details as promised for those that have shown interest.
Specas are :
12mm studs with a stud pattern of 4 x 110mm
Discs are 240mm dia x 10mm thick (solid)
Overall flange to flange width is 3190mm (approx)
Axle length is 1760mm
Axle minor dia is 25mm (approx)
Spline OD is approx 28mm and 28 spline
Floater hubs bolt on to axle housing and are 110mm long each side
RH End Housing/Floater hub ;
RH End Housing/Floater hub drive plate ;
RH End Housing/Floater hub drive plate & axle ;
Housing overall ;
Axle splines showing the axle with a slight twist ;
There have been a few peple expressing interest, and in order they are ;
Terry O'Bierne
taylz
Chris (phone contact)
Have a look at the pics and best bid wins ?
Cheers
Michael B
|
|
|
Location:
Adelaide
Registered:
September 2003
|
|
Re: FS : Full Floater diff/hubs Going Cheap ;-)
|
Sun, 09 January 2005 21:09
|
|
Any offers ?
It is going to the dump this Saturday if not offer materialises....
Cheers
Michael B
|
|
|
