| Author | Topic |
|---|
Location:
Perth
Registered:
August 2003
|
|
piston head design
|
Thu, 17 March 2005 20:27
|
 |
howdy, can anyone provide me link to a site or some general information of the design of piston heads. Like the different grooves on them etc.
How can you tell if a piston is forged or not?
also can anyone tell me why there is a little groove cut out on these pistons i have. Is the left piston down the bottom.
|
|
|
Location:
Melbourne
Registered:
May 2002
|
|
Re: piston head design
|
Thu, 17 March 2005 23:38
|
|
|
the notch go's to the front of the engine typicly
|
|
|
I Supported Toymods
Location:
Sydney
Registered:
December 2002
|
|
|
Location:
Perth
Registered:
August 2003
|
|
Re: piston head design
|
Fri, 18 March 2005 07:24
|
|
mine say ACL MY2 undernearth and 99 on the other side?
any idea?
|
|
|
Location:
Melbourne
Registered:
May 2002
|
|
Re: piston head design
|
Fri, 18 March 2005 08:24
|
|
|
www.acl.com.au
|
|
|
I Supported Toymods
Location:
Sydney
Registered:
December 2002
|
|
Re: piston head design
|
Fri, 18 March 2005 08:42
|
|
| jackel wrote on Fri, 18 March 2005 18:24 |
mine say ACL MY2 undernearth and 99 on the other side?
any idea?
|
Christ man did you even bother to open the link I posted.
THE ANSWER TO YOUR QUESTION IS IN THAT THREAD!
I EVEN TOLD YOU ROUGHLY HOW FAR INTO THE THREAD IT IS!!!!!
|
|
|
Location:
brisbane
Registered:
October 2004
|
|
Re: piston head design
|
Fri, 18 March 2005 09:17
|
|
i think you will find a lot of information if you looked
up head design/combustion chamber types, interference/non
interference heads, high comp/low comp heads etc...
cast/forged seems to be covered already
|
|
|
Location:
Perth
Registered:
August 2003
|
|
Re: piston head design
|
Fri, 18 March 2005 15:58
|
|
ah ok i see it now 
|
|
|
