Toymods Car Club
www.toymods.org.au
F.A.Q. F.A.Q.    Register Register    Login Login    Home Home
Members Members    Search Search
Toymods » Tech & Conversions » Using FWD cut and shut intake manifold in AE86

Show: Today's Posts  :: Show Polls 
Email to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
AuthorTopic
WHITCHY
Forums Junkie


Location:
Castle Hill
Registered:
August 2003
Using FWD cut and shut intake manifold in AE86 Mon, 18 April 2005 04:44 Go to next message
I have been reading heaps on GE conversions into AE86, and I have read a few people saying they mesured up the cut n shut manifold and it appeared as if it wouldnt fit under the bonnet?
Is anyone here using a cut and shit manifold?did they have any clearance problems?
Thanks for any info/advice!
Cheers!
-Whitchy-
  Send a private message to this user    
monkeymajik
Forums Junkie


Location:
Brisbane
Registered:
February 2003
Re: Using FWD cut and shut intake manifold in AE86 Mon, 18 April 2005 04:50 Go to previous message
Im using a bigport inlet manifold cut and shut. As long as you angle the inlet pipe on the front down, it will fit.
  Send a private message to this user    
  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic:Job for car audio enthusiast!
Next Topic:RA28 V8 upgrade?
Goto Forum:
-=] Back to Top [=-

Current Time: Mon Jul 21 07:09:55 UTC 2025

Total time taken to generate the page: 0.053574085235596 seconds

Bandwidth utilization bar

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.