Was going to cut these and put them in my car but have decided that i'll be going down a different path with my suspension setup due to bargain pickup over the week.

It's a set of 4. 2 front 2 rear... perfect if your looking for an easy upgrade for your stock setup or if your keen cutting them to make them a harder and much cheaper alternative to trd race springs which are hard to come by and expensive

Part numbers are 48131-AE811 and 48231-AE811

listed on the trd website

http://www.trdparts.jp/parts_spring.html


Hardly used!!!

chasing a measily $300 (+ shipping if ur interstate) for a perfect street setup coil for an AE86

Located Melbourne Australia
Pm for further questions or call me

shiri

[Updated on: Fri, 13 May 2005 06:44]

Yes rears are identical, fronts aren't by a long shot, but a bit of dodgy work with some nice thick fence wire can fix that

Kev.

Edit: Just realized that the TRDs look a bit different to AE86 stock front springs. Looks as though if you chop them the right amount at the small end then they should fit right in, and that chopping distance should be perfect with height too . (KE70/AE71 front springs are identical in proportions to rear springs).



For these springs to be a safe chop you will either have to get short stroke shocks or use a modified version of Sam_Q's wire trick, seen with my current TRD springs in this pic, I have since upgraded to RA28 struts that would fit the small end perfect, but yeah.. Basically you tie a wire around 2 points at each side, the cheapest short stroke setup known to man .

[Updated on: Wed, 18 May 2005 13:11]