Toymods Car Club Inc: Tech & Conversions => Info on Fitting and EBC and FCD to a 2JZGTE

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » Info on Fitting and EBC and FCD to a 2JZGTE Show: Today's Posts :: Show Polls Email to friend

Author

Topic

Southo
Regular

I supported Toymods

Location:
Sydney
Registered:
August 2002

Info on Fitting and EBC and FCD to a 2JZGTE	Wed, 15 June 2005 07:12

Hey guys, I am going to be fitting a Gizzmo FCD and Gizzmo EBC (as shown in the following links) to my Cressida with 2JZ-GTE http://www.gizzmoelectronics.co.nz/product_boost.h tm http://www.gizzmoelectronics.co.nz/product_boost.h tm Is there anything I should be wary of, or is there any special considerations when fitting a Fuel Cut Defender or Electronic Boost Controller to a 2JZ-GTE ?? Thanks Jason edit Forgot to mention.. I am running the Factory ECU, Turbos and Injectors etc, just with twin 2" dumps into a single 3" exhaust and big intercooler so it is hitting boost cut quite easily at around 5,000rpm as it is currently... [Updated on: Wed, 15 June 2005 07:28] [Report message to a moderator]

Norbie
Forums Junkie

Location:
Brisbane
Registered:
May 2002

Re: Info on Fitting and EBC and FCD to a 2JZGTE	Wed, 15 June 2005 23:38

On my car, fitting the FCD involved snipping one wire and about 5 minutes of soldering. Couldn't be easier. As for the EBC, I've never installed one but if you follow the instructions I can't see it being much harder. [Report message to a moderator]

Previous Topic:	Thermofan switching and hysteresis
Next Topic:	Ra60 brakes and calipers.

Current Time: Tue Mar 4 10:07:17 UTC 2025

Total time taken to generate the page: 0.0074069499969482 seconds

.:: Contact :: Home ::.