| Author | Topic |
|---|
Location:
Dubbo
Registered:
April 2005
|
|
Extractor Plates
|
Tue, 28 June 2005 07:01
|
 |
Hey all!
I am about to start a turbo install on my GT4 and was wondering if anyone here knows of somewhere to get extractor plates for the 3S-GTE (or 3S-GE if it is the same) mine is a Gen 2 motor
Nathan
|
|
|
Location:
Brisbane
Registered:
June 2003
|
|
Re: Extractor Plates
|
Wed, 29 June 2005 06:39
|
|
|
you will have to probly have them made up...
|
|
|
Location:
Dubbo
Registered:
April 2005
|
|
Re: Extractor Plates
|
Fri, 01 July 2005 04:00
|
|
damn i was worried about that  also, there is a turbo kit available but buggered if i can find the thread/website that i saw it on, anyone know of any companies that sell kits for our car in Aus?
|
|
|
Location:
Sydney
Registered:
February 2003
|
|
Re: Extractor Plates
|
Fri, 01 July 2005 10:20
|
|
Buy yourself a bit of 10mm steel plate ( Mascot Steel Fabrications if in Sydney are good for this )
Mark pattern off gasket
Drill with a good quality holesaw in a drill press
Cut to shape with a cutoff wheel in a small angle grinder
Buy a length of tube and a selection of bends from your local exhaust shop
Mig the tubes to the inside of the flange and braze on the outside to get a wide fillet, clean up the inside with a dremmel / die grinder.
Make the downstream flanges the same way.
Almost too easy
|
|
|
Location:
Kita-Ku, Sapporo, Japan
Registered:
January 2003
|
|
Re: Extractor Plates
|
Fri, 01 July 2005 10:24
|
|
i did that.. it was an absolute bitch of a job
i will always pay to have one laser cut in future...
|
|
|
Location:
Dubbo
Registered:
April 2005
|
|
Re: Extractor Plates
|
Sat, 02 July 2005 01:15
|
|
yeah i was hoping to avoid having to make the extractor plate, oh well looks like i haven't got a choice, no matter, shall be fun 
|
|
|
