| Author | Topic |
|---|
Location:
Brisbane
Registered:
February 2004
|
|
My Celsior - more hassles
|
Fri, 08 July 2005 10:04
|
 |
Well I finally managed to find some suitable wheels for it, 1995 GT-T Soarer wheels, not too bad looking and I got some new tyres for them for $110 each (some crap brand)
So, I replace the front ones, no problem, when I get to the back one, 2 of the 5 nuts are quite hard to get off, squelling with pain all the way, closer inspection sees that they are slightly bent, I snap a third one off and the last 2 never got so loose I could undo be hand.
What causes this? and is it difficult to replace them?
I have 4 out of 5 of the nuts on the car, is it ok to drive like that?.
|
|
|
I supported Toymods
Banned User
Location:
Brisbane
Registered:
May 2002
|
|
Re: My Celsior - more hassles
|
Fri, 08 July 2005 10:29
|
|
| Dust wrote on Fri, 08 July 2005 20:04 |
I have 4 out of 5 of the nuts on the car, is it ok to drive like that?.
|
It will be ok for a short while at low speeds. Just get the studs replaced ASAP.
|
|
|
Location:
Montrose, VIC
Registered:
May 2002
|
|
Re: My Celsior - more hassles
|
Fri, 08 July 2005 11:18
|
|
Replace all the studs on the car if in doubt - it doesn't cost very much and might just save you from something nasty 
|
|
|
Location:
Brisbane
Registered:
February 2004
|
|
Re: My Celsior - more hassles
|
Fri, 08 July 2005 12:35
|
|
yeah was thinkin that myself  , is it difficult? should I just get someone else to do it?
I dont want the wheels falling off while I am driving lol.
|
|
|
Location:
Sydney
Registered:
May 2004
|
|
Re: My Celsior - more hassles
|
Fri, 08 July 2005 12:49
|
|
| Dust wrote on Fri, 08 July 2005 22:35 |
I dont want the wheels falling off while I am driving lol.
|
 hehe done that one before in the rally car while taking it around the block! I blame it all on my co-driver!
|
|
|
