Toymods Car Club
www.toymods.org.au
F.A.Q. F.A.Q.    Register Register    Login Login    Home Home
Members Members    Search Search
Toymods » Tech & Conversions » Tube& Fin Vs. Bar & Plate

Show: Today's Posts  :: Show Polls 
Email to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
AuthorTopic
trueno_gze
Regular


Location:
Perth
Registered:
August 2002
Tube& Fin Vs. Bar & Plate Sun, 22 December 2002 03:54 Go to next message
hey ppl i kno this topic may have been brought up a few times but im in the market for a fmic for my ze trueno and il like to kno ur opinions on this topic...
and also the dfferences between the 2..
cheers aaron
  Send a private message to this user    
Chriph
Regular


Location:
Canberra
Registered:
May 2002
Re: Tube& Fin Vs. Bar & Plate Sun, 22 December 2002 05:57 Go to previous messageGo to next message
There's a really good explanation of the pros and cons of each on the ARE website, www.are.com.au
  Send a private message to this user    
SUPRAGTE
Forums Junkie


Location:
North Sydney
Registered:
May 2002
Re: Tube& Fin Vs. Bar & Plate Sun, 22 December 2002 08:43 Go to previous message
Tube and fin have a fair bit better flow. Bar and plate have a better cooling co-efficient, by about 30% for the same size tube and fin.

So you gotta have a 4.5inch thick bar and plate to get it to flow as well as a 75mm tube and fin.

I'm getting a tube and fin made up at the moment and just went through all the pro's and cons of both but that is the short and curly's of it.
  Send a private message to this user    
  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic:MX83 Cressida Cruise Control
Next Topic:ST162 gearbox hassles
Goto Forum:
-=] Back to Top [=-

Current Time: Fri Jul 18 11:22:29 UTC 2025

Total time taken to generate the page: 0.13698506355286 seconds

Bandwidth utilization bar

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.