Toymods Car Club
www.toymods.org.au
F.A.Q. F.A.Q.    Register Register    Login Login    Home Home
Members Members    Search Search
Toymods » Tech & Conversions » SuperPro Bush install - xA6x IRS Swing Arms

Show: Today's Posts  :: Show Polls 
Email to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
AuthorTopic
CrUZsida
Forums Junkie


I supported Toymods

Location:
Australia
Registered:
November 2003
SuperPro Bush install - xA6x IRS Swing Arms Sun, 04 December 2005 09:36
Has anyone installed the above bushes?

I just went to put my swingarms back on the crossmember, and 2 of the crush tubes are too long.

Where the 'inner' goes is 70mm, and the 'outer' is 65mm according to my measurements.
But all 4 tubes you get with the kit are 70mm.

I'm going to ring up about this tomorrow, but in the meantime, any one know?
  Send a private message to this user    
  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic:1jz stalling
Next Topic:gear ratios
Goto Forum:
-=] Back to Top [=-

Current Time: Mon Apr 29 09:59:14 UTC 2024

Total time taken to generate the page: 0.0034949779510498 seconds

Bandwidth utilization bar

.:: Contact :: Home ::.

Powered by: FUDforum 2.3.8
Copyright ©2001-2003 Advanced Internet Designs Inc.