| Author | Topic |
|---|
Location:
New Zealand
Registered:
September 2005
|
|
How to pull apart a CT20 - pics included
|
Wed, 07 December 2005 07:26
|
 |
My CT20 off my 3tgte is poked,heaps of radial play in the bearings/shaft + leaking oil seals,this is the first time iv taken one apart and need a little help from all u experts out there,the pics below show how far iv got,so.....how do i split the center bearing section from the turbine valute/housing,ive removed the compressor wheel but not the turbine wheel(i dont have to do i?) + removed the internal circlip behind the turbine wheel but she wont part,wats the secret? 
|
|
|
Location:
Melbourne
Registered:
October 2004
|
|
Re: How to pull apart a CT20 - pics included
|
Thu, 08 December 2005 13:39
|
|
|
From my very limited experience with turbos - the housings should both come apart if all the circlips have been removed. May need the use of a very big bar to lever it off due to the burnt up gunk that glues them together. Bear in mind that i have never played with a ct20 though, only a mitsu tc05.
|
|
|
Location:
Toowoomba
Registered:
May 2002
|
|
Re: How to pull apart a CT20 - pics included
|
Sun, 11 December 2005 14:08
|
|
|
I thought you needed some very specialized and acurate tools to work on turbo rebuilds??
|
|
|
Location:
Melbourne
Registered:
May 2002
|
|
Re: How to pull apart a CT20 - pics included
|
Mon, 12 December 2005 11:30
|
|
mix up a large bucket of 50% kero and 50% petrol, sit turbo in said bucket, come back once a day and hit the exhaust housing with a resin/hard plastic faced hammer and place it back in the bucket... couple of days should see it parted.... hopefully!
for now i would put the compressor side back together to stop the exhaust wheel floating around when your belting the shit out of it
|
|
|
