| Author | Topic |
|---|
Location:
Southern highlands - NSW
Registered:
January 2003
|
 3S-GE engine mounts for an SW20 MR2
|
Wed, 22 January 2003 11:51
|
 |
I need the front and rear engine ( actually transaxle ) mounts for an SW20 MR2 with a 3S-GE engine, mine are shot.
Hoping some one has some left over from a half cut or an engine swap. Might also be interested in a few other small parts.
|
|
|
Location:
Redbank Plains,near Ipswi...
Registered:
May 2002
|
|
Re: 3S-GE engine mounts for an SW20 MR2
|
Thu, 23 January 2003 22:24
|
|
|
I have these. $50 each + I want you old buggered ones as I rebond them in harder rubber for our race cars.
|
|
|
Location:
Hornsby, N.S.W
Registered:
September 2002
|
|
Re: 3S-GE engine mounts for an SW20 MR2
|
Mon, 27 January 2003 04:38
|
|
i have a set of 3sge mounts but they are celica ones, are they any help???
If yes then you can have all of them for $60+ postage
JUZZO
|
|
|
Location:
Southern highlands - NSW
Registered:
January 2003
|
|
Re: 3S-GE engine mounts for an SW20 MR2
|
Sat, 01 February 2003 01:21
|
|
Hey Juzzo, I dunno if you got the e-mail I sent you, but i'll post here just in case you didn't - I have been looking around the net and have found that the part no's for the celica and MR2 mounts are similar, there is a post on this forum where somebody says they have used them. I am going to attach a picture of my mounts, lemme know if you think yours are the same...
|
|
|
Location:
Southern highlands - NSW
Registered:
January 2003
|
|
Re: 3S-GE engine mounts for an SW20 MR2
|
Sat, 01 February 2003 01:37
|
|
G'day Terry, are the mounts you have s/hand or refurb?
Also would you have a rough idea what the postage would be for these as I've never had to post any larger items before, I am about 100kms south of sydney.
|
|
|
Location:
Southern highlands - NSW
Registered:
January 2003
|
 Re: 3S-GE engine mounts for an SW20 MR2
|
Wed, 05 February 2003 07:41
|
|
Anybody?? I think the engine is beginning to really
annoy the egine cover... 
|
|
|
Location:
Redbank Plains,near Ipswi...
Registered:
May 2002
|
|
Re: 3S-GE engine mounts for an SW20 MR2
|
Thu, 06 February 2003 22:09
|
|
|
the ones I offered were OK used ones. the (NEW) re-rubbered ones are $120 ea. postage would be about $8 ea at a guess. beware--each of these mounts are different for different models as they carry different loads in different ways. They have anti-vibration slots in them with hard rubber packers in the middle. The ones we get remade here are solid rubber (in various grades). We use them on all our race engines to stop problems like you seem to have. of course, a little virbration at some particualr rev value is not a hassle to us.
|
|
|
