Ok have emailed Grant about this but no reply yet...
Anyone out there know anything about this please reply.
Ok the car is going finally (YAY!)
However, the A/C lines aren't hooked up (Wiring)
and the tacho doesn't seem to be getting a signal. However I can get the signal for the S-AFC through the IGF wire...So it's seeing it through another way....I'll try to draw a diagram about my q's
Cressida Eng Loom..............Chaser Eng Loom
A/C Mag Relay <-- -->A/C Clutch
No Match---------------???----->A/C Amplifier
and
Tacho---------------------------Tacho
But the tacho wont register, the other things such as water temp work fine though...All engine lights are good too on the dash...Also the dash I am using is the original Cressida dash...
The A/C thing is the main thing that is bugging me, it's driving me up the wall, I have "EVERY" diagram and still cannot figure out the stupid thing. The rest of the wiring was hard but works ok.
Grant told me that your cressi tacho will not work with the 1J because the voltages are different. He actually makes a converter thingy to put between the two to make it work. MX83TOY has one on his car. The A/C i cant help you with. sorry.
Which 1J do you have?
Location: Newcastle, NSW, Australia
Registered: May 2002
Re: Wiring 1JZ Chaser
Wed, 05 February 2003 07:12
Farren,
I have now replied to your email. I've been sick with the flu for about a week so answering emails wasn't high on my priority list. If you don't follow what I've said in the email then please give me a call and we can talk through it.
As for the tacho, you will need one of my Tacho Boosters to drive the factory tacho from the 1J output. I'll send you some information.
Wed, 05 February 2003 04:15
