Question about cutting hole in bonnet for Levin scoop
Mon, 09 June 2003 08:28
Need info about cutting hole in AE92 bonnet.
For those that have done this - did you just cut out the same shape and size as original hole and then bend the front and rear edge down and bolt on the scoop. Did you reinforce it (weld where need) for strength.
Panel beater has suggested cutting a larger area from original Levin bonnet (about 6 inches out side the original hole) and then cutting same size hole in my Australian bonnet and welding it in.
I think this is going to cost me heaps and I need to let him know by tomorrow (Tuesday). Kevin
Mon, 09 June 2003 08:28
