Recently put in a 2TG with twin mikuni solex carbs and am not too
happy with my accelerator cable setup. Currently the cable comes
through a mounting plate which is attached between the carbs on the
outside. The cable goes down to the throttle arm which is between
the carbs.
The problem is that the springs on the throttle arm are quite tight
and due to the angle that the cable attaches to the throttle arm,
the first little bit of travel causes too much movement in the
throttle arm and so moving off from a standing start is a bit
difficult. Fine control at this point is difficult too.
Was wondering if anyone out there had some ideas about the best way
to do the setup?
Fri, 21 November 2003 02:38
