Toymods Car Club Inc: Tech & Conversions => 2tg dummy cam oil hole to cover or not......WHY?

Toymods Car Club
www.toymods.org.au

Toymods » Tech & Conversions » 2tg dummy cam oil hole to cover or not......WHY? Show: Today's Posts :: Show Polls Email to friend

Author

Topic

cwhelan
Regular

Location:
Adelaide, Semaphore
Registered:
September 2004

Re: 2tg dummy cam oil hole to cover or not......WHY?	Mon, 09 May 2005 05:01

There's always the smart arse huh.... But then again so am I at times. Thanks yellorolla on your reply, I will turn the pump with the "fully hectic (torque busting ear piercing bolt snapping) drill". If I give you the right RPM which won't be a problem then maybe the pressure reading I give might be of some significance. Yes that is right, I would have the engine out and checked in no time also, but am house sitting at the moment and won't be able to do it for another 2 weeks or so. I'd rather ponder on what else could be done on checking this than take out the engine agian. To be safe, I will strip the engine down and start again. This engine hasn't even been turned over yet since all of the machining, so yes, I'd rather be safe than sorry. So far it has nearly cost $3000 for the engine with machining. Pulling the welsh plug and turning the pump sounds a good idea, might try that first. Can I buy welsh plugs singularly? [Updated on: Mon, 09 May 2005 05:05] [Report message to a moderator]

Current Time: Thu May 9 05:07:49 UTC 2024

Total time taken to generate the page: 0.004910945892334 seconds

.:: Contact :: Home ::.