Hi there, I have just swapped camshafts, line up the Square cut outs with the arrows on the top of the journels, the ones that point toward you when you are standing infront of the engine... I set square cut out in the cam shafts up with those arrows whilst at top dead centre (The 2nd mark on the crank, if you were turning it clockwise) - and made sure it was TDC by putting a screw driver down the spark plug whole.
I then turned it over again to 10BTDC to set the distributer up, I have the Longer Rotor thing pointing at R1 (rear spark on cyc 1 - they fire at the same time?)
But it will not start, turning the engine over by hand, the spark plug fires at TDC on cyclinder 1(R1) or a bit before... but it wont start damnit.
Havent got a compression gauge to check if theres compression.
Anyone got any ideas? Looks as if its the Cam timing...
Sat, 28 May 2005 07:43
