Toymods Car Club Inc: Cars For Sale & Wanted => f/s QLD TA22,73 3TGTEU twin turbo with mod plates

Toymods Car Club
www.toymods.org.au

F.A.Q.

Home

Members

Classifieds » Cars For Sale & Wanted » f/s QLD TA22,73 3TGTEU twin turbo with mod plates Show: Today's Posts :: Show Polls Email to friend

Author

Topic

gussyboy2
Regular

Location:
Oxenford/gold coast
Registered:
October 2002

f/s QLD TA22,73 3TGTEU twin turbo with mod plates

Sun, 05 June 2005 06:52

As it says.

Motor as follows:
3TGTEU twin coil Twin spark
New leads
All done 6000kms ago
Linish and polish journels
Deck surface of block
Forged flat top piston set-The pistons come with the dome and were machined down to lower compression for more boost
Conrod bearings-king race-race spec
Main bearings-king race-race spec
Upgraded clutch
Full balance- This included from Harmonic balancer to Pressure plate
Oil cooler take off-The sandwich plate where the oilfilter connects to- he made me a new one to fit the larger oil lines and temp switch
"o" ring top of block-will never blow another head gasket
All rods and bolts were tested
New Timing chain
All work was done by Road and track
A bulletproof motor in very good condition

The Head fully serviced and tested elsewhere though fitted by the above

Turbos:
Custom high mount exhaust manifold for twin ct12's
cct12's are in great condition- i've had them completely apart, cleaned and serviced.
single pod filter
turbo smart dual stage boost controller
stainless dump pipes to the flex plate 3inch
and 3inch exhaust from there to dump in front of diff
stainless intake pipes
front mount intercooled
stage III BOV
Adjustable oil pressure to turbos

Others:
Micro tech mt series (fuel and ignition)is about 2yrs old
Injectors servived
VL turbo fuel pump
Stainless surge tank
10mm fuel lines all way
turbo EFI fuel return malpassi

All water hoses replaced
All new high pressure oil lines
Huge custom radiator-double the thickness of original

I've been running oil temp,2 oil pressure(1 for turbo feed line and the other for engine), Mallery monster tacho, boost and water temp gauges to make shore everything was in perfect order. As well as having the air temp gauge on micro tech handset. Custom console to hold these gauges

Car: TA22 1973 celica
Paintwork not so flash but still respectable-still gets alot of looks. WRX rally edition with purple pearl. Interior good condition. No cracks on dash. Carpet replaced 1yr ago with deep blue. Under lay was replaced at same time.
A ding in drivers door- havnt got picture of it yet(not big enough to damage any of the rest of the car). Was done in a car park-moving poles.

mods:
Lowered Pedders suspension
Mags as shown 205s 13inch 60series
Lock diff
up to 400hp tail shaft
w55 gearbox i think

I'm located in Oxenford, QLD.

$6500ono
Regretfull sale

Attachment: Celica.jpg
(Size: 56.98KB, Downloaded 643 time(s))
Attachment: Image001.jpg
(Size: 59.78KB, Downloaded 467 time(s))

[Report message to a moderator]

[Message index]

-=] Back to Top [=-

Current Time: Sun Jun 29 18:48:37 UTC 2025

Total time taken to generate the page: 0.0053198337554932 seconds

.:: Contact :: Home ::.