| Author | Topic |
|---|
Location:
MELB
Registered:
November 2005
|
|
2TG into AE71 igniion problems please help.this is baffling me!!!
|
Sun, 04 December 2005 02:00
|
 |
i have just put a running 2tg into my ae71. all bolted up no probs, fuel altenator and starter all compatible.
cranked for ages, didn't start. changed plugs and reset timing to what was supposedly 0 deg btdc. ran for periods of 15 sec at a time, feathering the throttle, wouldn't idle. gave it heaps af advance, between 16 and guessing 30 dg btdc, and started to run better. held a high idle, wouldn't rev over 4000 rpm. running real rough, about two or three cylinders.
checked each lead with a timing light, very intermittent spark on all cylinders including coil lead. and at varied rev ranges too.
using the same coil as off running motor, with condensor and bellis resistor etc.
only exhaust is extractors, not sure if less backpressure could be affecting it this much.
that's all i can think of, any other suggestions please let me know. i appreciate all help.
(i have cleaned dizzy cap and rotor button, AE71 coil, still running the same.)
|
|
|
